RE: Debugger & program termination

["Larry Paque" <larry@xxxxxxxxx>]

Thanks - that will help a lot.
I'll be looking forward to the improvements in the new version because it's
not uncommon at all to be debugging 2 or more programs at once.
Larry

-----Original Message-----
From: code400-l-bounces@midrange.com
[mailto:code400-l-bounces@midrange.com]On Behalf Of xuanchen@ca.ibm.com
Sent: Friday, February 07, 2003 12:00 PM
To: CODE/400 Discussion & Support
Subject: Re: Debugger & program termination


Larry,

If you check the "Use program profile" checkbox in Load Program dialog or
Attach dialog, the breakpoints set to the start up program will be saved.

But breakpoints in the added programs (after you debug session is running)
will not be saved.  This behaviour will be improved for next release.

Regards,

Xuan Chen, Debug for iSeries
(905) 413-3769 T/L 969-3769
xuanchen@ca.ibm.com





                      "Larry Paque"
                      <larry@paque.net>          To:       "Code400-L"
<code400-l@midrange.com>
                      Sent by:                   cc:
                      code400-l-bounces@m        Subject:  Debugger &
program termination
                      idrange.com


                      02/07/2003 12:40 PM
                      Please respond to
                      CODE/400 Discussion
                      & Support





I'm just learning to use the debugger so please be kind if this is a dumb
question - I didn't see it in the archive, so....

Every time I let a program I am debugging complete the debugger loses all
my
breakpoints, added programs, etc.  What am I missing ?   How do I run it
again without having to re-set my breakpoints?

WDSC 4.0, OS400 V5R2

Thanks,
Larry