Re: Variable named STEP

[berestet@xxxxxxxxxx]

Hi David,

If a variable name matches a name of one of the debugger commands (like
STEP, BREAK, etc.)
a special syntax is required.
In this situation, you will need to bring up the 'Monitor Expression'
dialog and enter the following:
%VAR(STEP).

This syntax will work for any variable, but only required for those that
match names of debugger
commands. In this scenario you will have to use 'Monitor Expression'
dialog.

Hope this helps,
Vadim Berestetsky
Distributed Debugger Development
Internet:  berestet@ca.ibm.com



David Wright <dwright@celsinc.com>@midrange.com on 01/15/2002 07:10:41 PM

Please respond to code400-l@midrange.com

Sent by:  code400-l-admin@midrange.com


To:   "CODE400-L (E-mail)" <CODE400-L@midrange.com>
cc:
Subject:  Variable named STEP


In my RPG400 programs, I have a variable named STEP which holds the next
routine the program will go to.  When I try to add STEP to the Program
Monitors, I get a popup 'CPF7E15 : Syntax Error Occurred'.

Is debugger interpreting this like a STEP in a For/Next loop?
_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L@midrange.com
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/cgi-bin/listinfo/code400-l
or email: CODE400-L-request@midrange.com
Before posting, please take a moment to review the archives
at http://archive.midrange.com/code400-l.




_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L@midrange.com
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/cgi-bin/listinfo/code400-l
or email: CODE400-L-request@midrange.com
Before posting, please take a moment to review the archives
at http://archive.midrange.com/code400-l.