Re: Distributed Debugger - Tool Tips (was UPDPROD)

[berestet@xxxxxxxxxx]

Hi Phil,

Sure, you can add variables to the 'Monitor' pane (bottom - left corner).
Just double-click to
highlight the variable. Then, bring up the pop-up menu (second mouse
button) and one of
the options will allow you to add this variable to the 'Monitor' pane.

Tooltip evaluation works fine for small strings and scalars. Complicated
data strucures do
require putting them into the 'Monitors' pane.

Hope this helps.
Vadim Berestetsky
Distributed Debugger Development
Phone (905) 413-4403; T/L  969-4403
Internet:  berestet@ca.ibm.com


Phil Groschwitz <sublime78ska@yahoo.com>@midrange.com on 11/27/2001
10:25:50 AM

Please respond to code400-l@midrange.com

Sent by:  code400-l-admin@midrange.com


To:   code400-l@midrange.com
cc:
Subject:  Distributed Debugger - Tool Tips (was UPDPROD)


Chris & Xuan - Thanks.

> BTW, if you
> enter the debugger from
> codeedit, you cannot set the update prod.

Thanks especially for this tidbit, Chris!

The next thing I ran into was seeing the value of the
variables.  I turned on tooltips.  Works fine except
for large strings.  The tool tip goes off the page so
I can't see the whole thing.  Is there another way to
see the value?  I was hoping to see the current values
of all visible variables in one of the panes on the
left side (like you can do in VAJ.).

Thanks very much,

Phil




__________________________________________________
Do You Yahoo!?
Yahoo! GeoCities - quick and easy web site hosting, just $8.95/month.
http://geocities.yahoo.com/ps/info1
_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L@midrange.com
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/cgi-bin/listinfo/code400-l
or email: CODE400-L-request@midrange.com
Before posting, please take a moment to review the archives
at http://archive.midrange.com/code400-l.