Debugging a batch job

[rob@xxxxxxxxx]

I am trying to debug a batch job.  I am following some instructions I have
which say to:
-SBMJOB CMD(....) HOLD(*YES)
-Start debugger with prompt.
-Get job info of submitted job
-Start debug session
-Release job
-Bring up your source from the Programs page
-Set line breakpoints.  Watches are not available while browsing.
-Run
-Start your program on the 400 when message tells you to.
-Dismiss message.

So I
-did the SBMJOB.
-Start, Programs, IBM Web Sphere Development Tools for iSeries, IBM
Distributed Debugger, IBM Distributed Debugger.
-made sure my host name was correct
-Turned off Step Into
-Specified the name of the program to add to debug
-Try to select the job to debug.  This is where I can't find the job.  This
is the job I am trying to debug:
Job            User           Number     Priority     Status
DOMSYN1000     QNOTES         083210        5          HLD
I tried DOMSYN1000/QNOTES/083210, */QNOTES/*, and whatever - no luck.

Any clues?

Rob Berendt

==================
"They that can give up essential liberty to obtain a little temporary
safety deserve neither liberty nor safety."
Benjamin Franklin