RE: Prompting CL without STRCODE

[Chris Proctor <cproctor@xxxxxxxxxxxxxx>]

Title: RE: Prompting CL without STRCODE

I agree, Doug. I just installed it and tried it.  A LOT nicer than STRCODE!! Thanks For the tip, Eric.  Now if it doesn't crash I'll be really happy!! ha ha. OK, so I'm a little leery about "AS IS" code!

Thanks!!

Chris Proctor
Gart Sports
Denver

-----Original Message-----
From: Douglas Edwards [mailto:Douglas.Edwards@alltel.com]
Sent: Friday, August 17, 2001 10:59 AM
To: code400-l@midrange.com
Subject: Re: Prompting CL without STRCODE

     A thing of beauty Eric!
    
     Just took a brief look, but the install went fine, and so far the
     prompting has worked well, both on IBM and in-house commands.
    
     Thank you!
    
     Doug Edwards

______________________________ Reply Separator _________________________________
Subject: Prompting CL without STRCODE
Author:  code400-l@midrange.com at INTERNET
Date:    8/17/01 8:56 AM

After a few posts from users, I posted at the end of April that we were
looking into being able to prompt CL using the same mechanism that OpsNav
uses from the AS/400 Toolbox.  This would avoid to need to have a STRCODE
session to prompt your CL statements from the CODE Editor.  Well, we now
have something for you to try out.
    
I have posted on the WDT400 website (exact link is below) the update.  A
couple of points:
1.  This update is provided AS IS.
2.  You have to have V5R1 of WDT400 with CODE Service Pack 1 or CODE
Service Pack 2.
3.  Read the instructions carefully.
    
http://www-4.ibm.com/software/ad/wdt400/support/codesupport.html#PromptingCLwith
outSTRCODE
    
Note: Occasionally, the graphical-user-interface that displays the prompted
CL statement appears behind the editor. If this happens, switch focus to
the graphical-user-interface.
    
Hope you find it useful,
Eric
    
Eric Simpson
IBM Toronto Lab
Phone:  (416) 448-3226,  T/L:  778-3226
Email and SameTime Connect:  esimpson@ca.ibm.com
    
_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L@midrange.com
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/cgi-bin/listinfo/code400-l
or email: CODE400-L-request@midrange.com
_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L@midrange.com
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/cgi-bin/listinfo/code400-l
or email: CODE400-L-request@midrange.com