RE: strcode through the firewall question.

["Vernon Reeve" <reeve@xxxxxxxxxxxx>]

That worked!!!  They set it up to do both incoming and outgoing and now it
works fine.

Thanks.

-----Original Message-----
From: owner-code400-l@midrange.com [mailto:owner-code400-l@midrange.com]On
Behalf Of Vincent Greene
Sent: Monday, April 23, 2001 2:06 PM
To: CODE400-L@midrange.com
Subject: Re: strcode through the firewall question.

They probably opened port 4200 INCOMING, when they should have opened
port 4200 OUTGOING.

I have also found Code/400 sometimes has a problem with address
translation and IP Tunnelling.

Vernon Reeve wrote:

> When I'm at the clients site, using client access to sign on to their
> 400, I can run the strcode command just fine.But when I'm signing on
> from home (still using client access) it just sits there until it
> times out.So I'm thinking it has something to do with their
> firewall.They've allowed access to port 4200 which is what the TCP/IP
> connection says it's using.Are there any other ports they need to
> allow access to?Or anything else I need to consider?
>

+---
| This is the CODE/400 Mailing List!
| To submit a new message, send your mail to CODE400-L@midrange.com.
| To subscribe to this list send email to CODE400-L-SUB@midrange.com.
| To unsubscribe from this list send email to CODE400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: larry@paque.net
+---

+---
| This is the CODE/400 Mailing List!
| To submit a new message, send your mail to CODE400-L@midrange.com.
| To subscribe to this list send email to CODE400-L-SUB@midrange.com.
| To unsubscribe from this list send email to CODE400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: larry@paque.net
+---