Only partial member list loads in filter...

["Jack Mullins" <jmullins@xxxxxxxxxxx>]

Hello!

I'm having problems with a member filter in CODE Project Organizer.  The
filter was originally setup as LIBRARY/QSOURCE(*) and it worked fine.  Then,
I accidentally clicked the filter while trying for another filter in this
particular project and all of the members in LIBRARY/QSOURCE(*) begin to
load.  However, I was in a hurry; so, I clicked STOP which stopped the
filter after about 20% of the members had been loaded.  I didn't think
anything about it and went on to the filter I was originally looking for.
But now, LIBRARY/QSOURCE(*) always loads only 20% of the members in this
file!  If I want anything past this 20%, I have to set the filter to pull
the members explicitly or at least use something like LIBRARY/QSOURCE(SHP*).
Has anyone else had this problem?  I have deleted the filter and recreated
it only to find that it still only loads 20%.  On a different workstation, I
created the same filter and it pulls 100% of the members.


73,

Jack Mullins
Sun Ergoline
P.O. Box 2026
Jonesboro, AR 72402
http://www.sunergoline.com
jackm@sundash.com
870.935.1130 x 109

+---
| This is the CODE/400 Mailing List!
| To submit a new message, send your mail to CODE400-L@midrange.com.
| To subscribe to this list send email to CODE400-L-SUB@midrange.com.
| To unsubscribe from this list send email to CODE400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: larry@paque.net
+---