RE: Word Document

["Taylor, Mike" <Mike.Taylor@xxxxxxx>]

Thanks. I have it working now. It was the Client Access properties on the
incomming remote access. I also took out the program file and just put the
document in the remote command. That way it does not lock the AS400 session.

Thanks again

> -----Original Message-----
> From: Winchester Terry [SMTP:terry.winchester@raymondcorp.com]
> Sent: Thursday, April 11, 2002 2:17 PM
> To:   'cobol400-l@midrange.com'
> Subject:      RE: Word Document
>
> Bummer.  I don't know anything about NT4 security.
>
> Have you got a PC tech person (MSCE type) that can check this?
> Sorry, can't help much.
>
> If you don't find much help from others on the mailing list
> you could also do some searching at:
>
> http://www.iseriesnetwork.com/Forums/Search.cfm?CFApp=58&un=f3r6sg
>
> Highlight all the areas in the "scope" list and enter "remote command"
>
> Good Luck,
> Terry
>
>
> > -----Original Message-----
> > From: Taylor, Mike [mailto:Mike.Taylor@aig.com]
> > Sent: Thursday, April 11, 2002 8:46 AM
> > To: 'cobol400-l@midrange.com'
> > Subject: RE: Word Document
> >
> >
> > NT 4
> >
> > > -----Original Message-----
> > > From:     Winchester Terry [SMTP:terry.winchester@raymondcorp.com]
> > > Sent:     Thursday, April 11, 2002 1:38 PM
> > > To:       'cobol400-l@midrange.com'
> > > Subject:  RE: Word Document
> > >
> > > Is it an NT or Win2K box?  If so, maybe its a security problem.
> > >
> > > Also check the Client Access properties for the Incoming Remote
> > > command daemon. If your running CA/Express it can be set up
> > > for generic security.
> > >
> > > If its a Win95 or Win98 box I would also look to see if file/print
> > > sharing is turned on.  Not sure if this has any impact.
> > >
> > >
> > > > -----Original Message-----
> > > > From: Taylor, Mike [mailto:Mike.Taylor@aig.com]
> > > > Sent: Thursday, April 11, 2002 8:25 AM
> > > > To: 'cobol400-l@midrange.com'
> > > > Subject: RE: Word Document
> > > >
> > > >
> > > > Thanks.
> > > > I have got that side working but I am getting "access denied"
> > > > error messages
> > > > when trying to connect to the PC to run the application.
> > Any ideas?
> > > >
> _______________________________________________
> This is the COBOL Programming on the iSeries/AS400 (COBOL400-L) mailing
> list
> To post a message email: COBOL400-L@midrange.com
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/cgi-bin/listinfo/cobol400-l
> or email: COBOL400-L-request@midrange.com
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/cobol400-l.