Re: FW: ASSET question

You have to look in the AS/Set subsystem and the compile listing are
there.


Just do WRKACTJOB and place an 8 next to the subsystem job

Dan Sweeney
Senior Technical Consultant
PHOENIX Business Consulting, Inc.
Tel: 860-432-9881, Cell:  860.490.6712, 
Fax: 860-432-9881
www.phoenixbcinc.com




-----Original Message-----
From: bpcs-l-bounces+dsweeney=phoenixbcinc.com@xxxxxxxxxxxx
[mailto:bpcs-l-bounces+dsweeney=phoenixbcinc.com@xxxxxxxxxxxx] On Behalf
Of LGronewold@xxxxxxxxxxxxxxx
Sent: Monday, December 04, 2006 6:03 PM
To: bpcs-l@xxxxxxxxxxxx
Subject: [BPCS-L] FW: ASSET question

Hi,

When compiling an ASSET program when it shows an O-, how do you find

what

you error are?  Where do you look?  I have looked at the source

listing

and it shows nothing.

Thanks in advance for any help.

Lori

********************************Disclaimer******************************
*****
The preceding e-mail message (including any attachments) contains
information that may be confidential, be protected by the
attorney-client
or other applicable privileges, or constitute non-public information. It
is intended to be conveyed only to the designated recipient(s). If you
are
not an intended recipient of this message, please notify the sender by
replying to this message and then delete it from your system. Use,
dissemination, distribution, or reproduction of this message by
unintended
recipients is not authorized and may be unlawful.
************************************************************************
*****