BPCS Reorg job

[RickCarter@xxxxxxxxxx]

AS400  Mix Mode   BPCS V6.1.01

Job SYS120C has stopped running successfully.  This job was running fine
but I noticed today that it wasn't running anymore.  I can't say when it
stopped running as it doesn't really give a noticeable error msg and the
operator did not catch this.   When I run this in a controlled environment
today, I captured the msg below but it doesn't tell me much or I don't
understand what it's telling me.  I am running this with the correct lib
list and all object authority.

It says there is a file missing from BPCSF but it doesn't say which file it
is.  Does anyone know if there's some type of system file residing in
BPCSF that has anything to do with the SYS120C job running.  Basically the
msg below is what is showing in the joblog.

   Message . . . . :  -CALL SYS126 PARM('BPCSF     ' 'Y' 'N' 'N' '  ')
 40    04/02/01   13:58:44   QLIROHDL       QSYS        00D8     SYS126
B
   Message . . . . :   File  in library BPCSF not found.
   Cause . . . . . :   The file name or the library name is not correct.
If th
     library name was not specified, the file may be in a library that is
not
     contained in the library list. Recovery  . . . :   Correct the file or
     library name, or add the library name to the library list.  Then try
the
     request again.
 40    04/02/01   13:58:45   QMHUNMSG                   *N       SYS126
B
   Message . . . . :   Function check. CPF9812 unmonitored by SYS126 at
stateme
     74300, instruction X'030C'.
   Cause . . . . . :   An escape exception message was sent to a program
which
     did not monitor for that message. The full name of the program to
which th
     unmonitored message was sent is SYS126  . At the time the message was
sent
     the program was stopped at higher level language statement number(s)
74300
     If more than one statement number is shown, the program was a bound
program
 Optimization does not allow a single statement number to be determined. If
 *N is shown as a value, it means the actual value was not available.
 Recovery  . . . :   See the low level messages previously listed to locate
 the cause of the function check.  Correct any errors, and then try the
 request again.


+---
| This is the BPCS Users Mailing List!
| To submit a new message, send your mail to BPCS-L@midrange.com.
| To subscribe to this list send email to BPCS-L-SUB@midrange.com.
| To unsubscribe from this list send email to BPCS-L-UNSUB@midrange.com.
| Questions should be directed to the list owner: dasmussen@aol.com
+---