Re: Labor Reporting - Kronos

["Chick Doe" <Cdoe@xxxxxxxxxxxxxxxxxxxxxx>]

we looked at this a couple of years ago so my information is dated. a lot can 
happen in two years.

be very specific about what transactions you want to collect. do you want times 
only, quantities, good units, scrap units? do you want only operation reporting 
or do you want to use the bpcs backflushing functionality? as i remember kronos 
did not support any backflushing which means you will have to collect both 
labor and material transactions separately. (again this was two years ago!)

i'd also be concerned about the statement that you made that said that the 
kronos software can run on either the as/400 or a pc box? is this the data 
collection software? or is it the software that will actually update the bpcs 
files? and what about the statement that they say that they will program the 
interfaces? are these custom for you? if they already have their system working 
at other bpcs sites, why would they need to reprogram them again for you.

bottom line - as best i remember kronos supported the bpcs inventory 
transactions 'out of the box'. with custom programming they could do the labor 
reporting transactions. they did not even come close to supporting the 
backflush transactions. 

DISCLAIMER - PLEASE REMEMBER THAT THESE COMMENTS ARE BASED UPON PRESENTATIONS 
AND STUDIES FROM A COUPLE OF YEARS AGO AND THAT THINGS SOMETIMES GET DISTORTED 
THROUGH TIME IN MY FEEBLE BRAIN.  

>>> tbutala@dentsply.com 07/19/00 09:46AM >>>


I would like to know if anybody out there has interfaced the Kronos Labor
Reporting System (Not the same as Kronos Payroll) into BPCS and the
corresponding pluses and negatives.  We currently are running on BPCS 6.04.  It
is my understanding that the Kronos Labor system can run on either the AS/400 or
on a PC Network and that all labor reporting comes from the Kronos software
itself.  Also, Kronos is claiming that they will program the interfaces from and
back into the BPCS system.  One of our divisions are all hot to move to this, I
have not received any of the documentation on the package yet but I though I
would toss it out there for discussion.  Thanks.


+---
| This is the BPCS Users Mailing List!
| To submit a new message, send your mail to BPCS-L@midrange.com.
| To subscribe to this list send email to BPCS-L-SUB@midrange.com.
| To unsubscribe from this list send email to BPCS-L-UNSUB@midrange.com.
| Questions should be directed to the list owner: dasmussen@aol.com 
+---

+---
| This is the BPCS Users Mailing List!
| To submit a new message, send your mail to BPCS-L@midrange.com.
| To subscribe to this list send email to BPCS-L-SUB@midrange.com.
| To unsubscribe from this list send email to BPCS-L-UNSUB@midrange.com.
| Questions should be directed to the list owner: dasmussen@aol.com
+---