Re: A night running of the programs

[alison_quinton@xxxxxxxxxxxxxx (Alison Quinton)]

We run INV920 as part of our nightly dayend suite via the IBM jobscheduler,
we use two commands, the first sets up the security and the second
calls INV921B, this is all we run. We are on BPCS 6.0.2 mm plf. 
> CALL SYS664 PARM('SYS664')                     
>           
> CALL PGM(INV921B) PARM('I' ' ' ' ')

I hope this helps.
 

Barlova wrote:

We have a problem with a night running of the program "INV921B". We have
BPCS v. 6.04 but we don´t have source programs. We know to start the
program "INV921B" by the following command:
SBMJOB CMD(CALL PGM(SYS003B) PARM('INV921B' 'X' 'X'))
But after this program run programs "CEA502B3", "CPR088B",
"CPR002C1","CPR009B". Because we don´t have source programs we don´t know
which parameters we need to pass to these programs and we don´t know to
start these programs. When the job "INV921B" ends in the output queue there
is a report "CEA200O". If you have some experiences with this job, send us
your advices. Thanks.

+---
| This is the BPCS Users Mailing List!
| To submit a new message, send your mail to BPCS-L@midrange.com.
| To subscribe to this list send email to BPCS-L-SUB@midrange.com.
| To unsubscribe from this list send email to BPCS-L-UNSUB@midrange.com.
| Questions should be directed to the list owner: dasmussen@aol.com
+---

--
Alison Quinton
Alison_Quinton@uk.xyratex.com
http://www.xyratex.com/