For "learned routes" I've use the procedure below.
NETSTAT
2. Display IPv4 route information
Find route in question
CHGTCPA
Change to 90
IP reassembly time-out . . . . . 90 5-120, *SAME, *DFT
Wait 2 minutes
F5=Refresh
Route in question should be gone.
CHGTCPA
Change back to 120
IBM Incident Summary
Document Number: 21031416
____________________________________________________________
Functional Area: Print
SubFunctional Area: Network Print from iSeries
SubSubFunctional Area: General
____________________________________________________________
Product:
Release: R440
Classification: Entitled/Advanced
Keywords:
____________________________________________________________
Document Title:ICMP Unable to PING Printer IP Address Document Problem Summary:
IBM(r) OS/400(r) spooled files will not print to a LAN-attached printer, because the printer's IP address cannot be PINGed successfully from OS/400(r) .
Resolution:
Option 2 (Display TCP/IP route information) from the Work with TCP/IP Network Status (NETSTAT) command showed that an *ICMP route destination existed with the printer's IP address.
This problem was resolved by using the Change TCP/IP Attributes (CHGTCPA) command to set the IP reassembly time-out (IPRSBTIMO) parameter to 90.
This will cause OS/400(r) to delete aged ICMP redirect routes and allow IP packets to pass through the correct interface to the printer.
References:
None identified.
Paul
-----Original Message-----
From: MIDRANGE-L [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Rob Berendt
Sent: Thursday, March 23, 2017 11:23 AM
To: Midrange Systems Technical Discussion
Subject: Re: How to clear old routes
Any of these help?
https://www-304.ibm.com/support/docview.wss?uid=nas8N1015699
http://www-01.ibm.com/support/docview.wss?uid=nas8N1017311
https://www.itjungle.com/2014/03/05/fhg030514-story03/
Rob Berendt
--
IBM Certified System Administrator - IBM i 6.1 Group Dekko Dept 1600 Mail to: 2505 Dekko Drive
Garrett, IN 46738
Ship to: Dock 108
6928N 400E
Kendallville, IN 46755
http://www.dekko.com
From: Chris Bipes <chris.bipes@xxxxxxxxxxxxxxx>
To: "'Midrange Systems Technical Discussion'"
<midrange-l@xxxxxxxxxxxx>
Date: 03/23/2017 11:08 AM
Subject: How to clear old routes
Sent by: "MIDRANGE-L" <midrange-l-bounces@xxxxxxxxxxxx>
We have just installed a new faster MPLS network. I have updated all the
default routers, adding the new routes and removing the old routes.
I still have one iSeries at V6R1 that is still using the old route. I
verified it is not in the local routing list, cfgtcp - Work with TCP/IP
Routes.
So it is sending data down the old route and receiving the responses
through the new route. (Not the best situation.)
Anyone know how to flush the learned routing table on an iSeries at 6.1?
Chris Bipes
Director of Information Services
CrossCheck, Inc.
As an Amazon Associate we earn from qualifying purchases.