×
The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.
It should be possible with the open source tn5250
http://tn5250.sf.net
But you'll have to figure out how to compile the code on Mac and get it
running. (If I had a Mac, you can bet it would be all set and ready to
go...)
The tricky part, though, will be adjusting the command syntax based on
the OS. For example, the 'rundll32' and 'start' commands typically used
with STRPCCMD are unlikely (?) to work with Mac. The directory
structure is likely to be different. etc, etc. So your CL program
would have to send a different command for MAC vs. Windows. (At least,
i'm assuming that... again, I don't have a Mac.)
I've run into that problem with FreeBSD vs. Windows, though.
On 11/10/2010 1:23 PM, Chris Bipes wrote:
Does anyone know of a TN5250 client for a MAC that supports the STRPCO
command? We launch commands to display images. If not using STRPCO is
there another way for an application to tell a MAC to open and display
an image in a separate window?
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact
[javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
