Did you try rebooting the printer? The printer can get in a compressed
print mode or set a default font running a print job from another
source. Normal spool file output from the i doesn't necessarily reset
it. Turning the printer off and back on again will sometimes fix it.
There's also a reset to factory defaults in the printer's configuration
menu that'll do it.
Also note that your 11 x 17 reports (132 characters wide) will use COR
(Computer Output Reduction) by default when printing to an 8.5 x 11
page. COR makes the font small and turns the page 90 degrees so your 132
characters fit inside 11 inches with some margins. There's a number of
ways to turn that off on the i depending on your setup.
Do you have HPT turned on?
-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Jon S
Sent: Thursday, July 01, 2010 1:31 PM
To: midrange-l@xxxxxxxxxxxx
Subject: Remote Outq Question
I have a customer that has an HP 4200N printer that we have setup to use
as a remote outq to print from the i. It works fine but is printing
really small. It is an IP attached printer. I have tried raw, text and
xaix for the RMTPRTQ and *HP4, *HP5 and *HP4000 for the MFRTYPMDL, but
the font stays the same. Does anyone have any ideas?
Thanks in advance,
Jon
_________________________________________________________________
Hotmail is redefining busy with tools for the New Busy. Get more from
your inbox.
http://www.windowslive.com/campaign/thenewbusy?ocid=PID28326::T:WLMTAGL:
ON:WL:en-US:WM_HMP:042010_2
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
list To post a message email: MIDRANGE-L@xxxxxxxxxxxx To subscribe,
unsubscribe, or change list options,
visit:
http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx Before posting, please take a
moment to review the archives at
http://archive.midrange.com/midrange-l.
midrange.com
