After the last message, I went back through the steps that were on your
site. I followed them and ran the TAR command again from QP2TERM. The
command seemed to run successfully, but this is what I see when I try to
use the 7-Zip command 7z (I should see the help screen):
/usr/local/bin/7z
/usr/local/bin/7z: {Z@a^Ã^Ã^ÃaÂ^Ã%^?aÃÃ^Ã^Ã^ÃÃÂÂaâÂ
^Ãa^Ã^Ã^Ã^Ã^Ãa^Ã^Ã^Ãa^ÃÃÂ^Ã^ÃaÃÂ^?@^?[: not found.
/usr/local/bin/7z: ^?%: not found.
$
Since I can't really see the message, so I'm not sure what to look at next.
Again, my guess was this is related to a CCSID issue of some sorts.
I'll try to be more specific in the future.
Matt
|------------>
| From: |
|------------>
>--------------------------------------------------------------------------------------------------------------------------------------------------|
|Scott Klement <midrange-l@xxxxxxxxxxxxxxxx> |
>--------------------------------------------------------------------------------------------------------------------------------------------------|
|------------>
| To: |
|------------>
>--------------------------------------------------------------------------------------------------------------------------------------------------|
|Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx> |
>--------------------------------------------------------------------------------------------------------------------------------------------------|
|------------>
| Date: |
|------------>
>--------------------------------------------------------------------------------------------------------------------------------------------------|
|12/24/2009 10:16 AM |
>--------------------------------------------------------------------------------------------------------------------------------------------------|
|------------>
| Subject: |
|------------>
>--------------------------------------------------------------------------------------------------------------------------------------------------|
|Re: 7-Zip On IBM i |
>--------------------------------------------------------------------------------------------------------------------------------------------------|
What do you mean by "the output is garbled"? Please be specific.
MattLavinder@xxxxxxxxxxxxxxxxxxx wrote:
You're right. I did install from QShell. Wasn't aware of the
differences
between running from QShell and QP2TERM. Did some research and see that
is
does make a difference. Should have followed instructions.
Another issue I am running into though is my output in QShell is fine,
but
when I run in QP2TERM, the output is garbled. Obviously a CCSID issue,
but
I am not sure what I need to do to resolve it.
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit:
http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at
http://archive.midrange.com/midrange-l..
midrange.com
