|
Cd-rom drive....not cd-rom as in the disc -------------------------- Sent from Jim Norbut's BlackBerry -----Original Message----- From: Norbut, Jim <Jim.Norbut@xxxxxxxxxxxxxxx> To: 'midrange-l@xxxxxxxxxxxx' <midrange-l@xxxxxxxxxxxx> Sent: Thu Nov 03 21:12:45 2005 Subject: Re: Howto get full SRC info That error sounds suspiciouslly like the error we got when we upgraded our 270 for v5r1 to v5r2 and it turned out we had a cd-rom in the machine that needed to be replaced because it was just having a heck of a time reading from the cd and apparently timing out or some sort of anomoly like that We had 3 ibm ce's out and they all were scratching their heads when it worked with the new cd-rom -------------------------- Sent from Jim Norbut's BlackBerry -----Original Message----- From: midrange-l-bounces@xxxxxxxxxxxx <midrange-l-bounces@xxxxxxxxxxxx> To: Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx> Sent: Thu Nov 03 20:57:44 2005 Subject: Re: Howto get full SRC info Antonio, You are correct. When the server stops yellow light on an SRC it displays word 11 by default. You may then up arrow to word 12 and press enter (blue) to display it. Same with 13 etc. Some words may be all 0's. Additinally some SRCs populate more words than others so just keep pressing up and enter until no more words are available. - Larry Antonio Fernandez-Vicenti wrote: > Folks, we've been having some problems upgrading from V5R2 to V5R3 ... > (already 2 weekends, reverting back to V5R2...) > We reported getting SRC : B600F103 during Microcode loading , for > which all available info seems to be meaningless. > IBM people have asked to repeat our "upgrade trial", even though we > know it will again fail, so as to be able to "fully describe" our SRC, > including not only the SRC itself, but also "words" 12, 13, ... thru 19. > > I've been looking to some manuals (e.g. "Basic Systems Operations") > and searched thru Google to find "detailed procedure to get word 12, > 13, etc" > Lot's of places mention how important these additional words are... > Some even mention "some servers had leds displays that show even four > words at a time", etc > > But so far have not been able to find a place that really explains > step by step how to display all those words... > Our system is a 820. Leds display only shows 8 hex digits. > > When we get SRC B600F103... > - do I just have to press the arrow "up" , then the white button to > see word 12? > - same again for other words? > - or is arrow "down" and blue/gray button? > - or... which key sequence in detail? > > I've never done this, and find really stupid asking what seems to be > something that should be so clearly explained somewhere in a manual... > > Any help? TIA >
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.