|
Which manual or manuals from the info center should we look at?
Thomas Hauber Senior Programmer/Analyst General Ribbon Corp.
Mike wrote:
Mike,
The Service Director at V5R3 is incorporated into 5722 SS1. You no longer need the Licensed Program 5798 RZG. It sounds like you are trying to start the old Service Director subsystem in your start up program. End the old Service Director subsystem and remove it from your start up program.
Once you have done that, do GO SERVICE and follow the instructions from there. It will force you to do the setup. I would HIGHLY recommend that you go to the Info Center and read how to do that. There are some changes in there that you need to understand.
<hth>
Mike Shaw
-----Original Message----- From: midrange-l-bounces@xxxxxxxxxxxx [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Condon, Mike Sent: Thursday, December 02, 2004 7:12 AM To: Midrange Systems Technical Discussion Subject: RE: V5r3 Service Director
Yes, but pours was "broke" for some reason after our v5r3 upgrade - I need to set up/enable it.
-----Original Message----- From: midrange-l-bounces@xxxxxxxxxxxx [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of rob@xxxxxxxxx Sent: Wednesday, December 01, 2004 3:36 PM To: Midrange Systems Technical Discussion Subject: Re: V5r3 Service Director
I think it's "just there". Check out the Memo to Users.
Rob Berendt
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.