Re: ftp quote command not working

["Bruce Jones" <bruce@xxxxxxxxxxx>]

I cannot get iSeries Navigator connected to client machine.  Only our
iSeries are allowed to connect.  Is there any way to see if remote command
is running from green screen?

I did check on the local iSeries.  The "Remote Execution" is Stopped on our
machine so I tried it from a dos box:
230 BRUCE logged on.
ftp> quote rcmd sndmsg hello bruce
250 Command sndmsg hello bruce successful.
ftp>

So, is the Remote Execution the same as remote command?  If not, I don't see
remote command. And, it appears that even though it is Stopped, it still
works.  Unless I don't see it correctly.


On the exit points, I'm not sure I'm reading it correctly either.  On
cliente machine:
Exit point . . . . . . . . . . . . . . :   QIBM_QTMF_CLIENT_REQ
Exit point format  . . . . . . . . . . :   VLRQ0100

Exit point registered  . . . . . . . . :   *YES
Allow deregister . . . . . . . . . . . :   *YES
Maximum number of exit programs  . . . :   1
Current number of exit programs  . . . :   0

Exit point . . . . . . . . . . . . . . :   QIBM_QTMF_SERVER_REQ
Exit point format  . . . . . . . . . . :   VLRQ0100

Exit point registered  . . . . . . . . :   *YES
Allow deregister . . . . . . . . . . . :   *YES
Maximum number of exit programs  . . . :   1
Current number of exit programs  . . . :   0

I'm reading both of those exit points as having zero current number of exit
programs defined.  Is that correct?

Thanks,
Bruce