Ang: Re: Restore 21 to a new Iseries

[Jan.Rockstedt@xxxxxxxxxxxx]

Hi Oliver !

Same version/release on both as/400.
No op-console.

Mvh / Regards Jan Rockstedt
HSB Syd IT
Spangatan 37B, 2:a van.
211 53 Malmo Sweden
Phone: +46-40 - 668 07 45
Fax: +46-40-668 07 55
www.sydit.hsb.se




oliver.wenzel@xxxxxxxxxxxxxxxxxxxxxxx
Sänt av: midrange-l-bounces@xxxxxxxxxxxx
2003-12-11 16:04
Sänd svar till Midrange Systems Technical Discussion
 
        Till:   Midrange Systems Technical Discussion 
<midrange-l@xxxxxxxxxxxx>
        Kopia: 
        Ärende: Re: Restore 21 to a new Iseries
Hi Jan,


>Soon is our S30 scrap iron.
>We have got a new 810 now. :-)
>Could someone point to any document how to run a restore 21 to a new 
>Iseries ?
>Or suggest any recomendation ?

We just switched from our 820 to our new 810 (basically a scratch reload).

As the hardware will not be the same, you'll have to check your device 
descriptions 
and connect them to the right controllers.

Do you have a twinax or OpsConsole? Make sure the Opsconsole is on the 
correct release
version. Also, be prepared to fight with OpsConsole cabling!

Whe we did the V5R2 upgrade of our 820, suddenly it wanted the OpsConsole 
cable in another
slot!

What release is your S30? It would be best if its the same as on the new 
810.

Regards,

Oliver
_______________________________________________
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing 
list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.