Printer Margins

["Smith, Dave" <dsmith@xxxxxxxxx>]

Bill and Bryan:

Thank you!!! This helped immensely.  I was able to set my margins and
everything is printing where it should.  Its still truncating the last three
characters on the right border but I sure with the info you have supplied, I
will figure it out.

Thanks again!

>You should be able to adjust the margin by creating a workstation
>customization object for the outq.  Use the RTVWSCST (retrieve workstation
>customization) command to get the source for your printer type.  Edit the
>source to modify the values for the NOPRTBDR sections for top and left.  I
>have the values set at 60 for top portrait and 0 for left portrait for an
>HP5, but you may need to try different values to see what will work in your
>situation.  You then need to create the object (CRTWSCST) so that you can
>use it for the Workstation Customizing Object value on the CRTOUTQ command.
>It's really not as bad as it sounds.  Don't know if there is another way,
>but this works for us.
>Bill Claes

>Dave, See if the following helps:
>http://www-912.ibm.com/s_dir/slkbase.nsf/1ac66549a21402188625680b0002037e/0
3d903f20df01f3f862565c2007d0e74?OpenDocument&Highlight=0,CNVDEN
>Bryan Dietz