Re: HIPER and Y2K PTFs

At 09:37 02/09/2000 , Debbie Gallagher wrote:
>Then on PTF menu, used Option 2 Apply PTFs. Press Enter. This took only a
>couple of minutes.
You need to run APYPTF once for each program product for which PTFs are 
being applied. Usually this is at list 5769999 and 5769SS1. It would be the 
same list you used when loading PTFs. Since you must IPL anyway, you may as 
well just schedule all PTFs to run during the IPL. When you do IPL, be sure 
to specify IPLSRC(B). If you don't, nothing will apply. After the system 
comes up, use WRKLICPGM opt 50 to display PTF messages. If they look OK, 
use DSPPTF to confirm that everything you think is applied is in fact applied.

Pete Hall
pbhall@execpc.com
http://www.execpc.com/~pbhall
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---