Re: Risc-to-Risc upgrade pitfalls

benji@intercomputer.hu wrote:
> 
> Hi,
> 
> I need some input on upgrading from a RISC box running V3R7 to a new 720 
>running
> V4R4. The source system is a model 400. We plan to upgrade the source system 
>to
> V4R4 in two steps (V3R7->V4R3->V4R4), save the entire system, and restore it 
>to
> the new hardware. We only move the 8mm drive from the source to the target.
> I am particullary interested in  pitfalls not documented in the Roadmap and/or

SInce you are RISC to RISC the "road map" does NOT apply... Once you get
the
400 up to current levels, a simple save & restore is about all you will
need
to deal with as far as libraries(user) are concerned... 

That will NOT carry forward any system values, hardware configs, etc..
They
will need to dealt with on an individual basis...

You will need to save and restore user profiles and authorities
You will need to examine any changed system values.
You will need to examine any hardware changes(remote controller
names,etc)
You will need to review any major hardware differences...(device names)
You will need to review subsystems that you have created.
You will need to review all LP's....
You will need to review your QSTRUP program...
You will need to review what security level you are at....

I'm sure I'm leaving several items off, but a box swap just requires a
check list of what goes across manually or can it be saved & restored...

Certainly a good bit can be saved and restored, but you still need a
plan...
Restoring your libraries is proably the "last" step....
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---