Thanks Dave!
I will most definitively will give this a try and give some feedback
later.
Thanks again!
Peter Vidal
MAPICS IT TECHNICAL SUPPORT TEAM / SR SYSTEM ANALYST
10540 Ridge Rd., Suite 203, New Port Richey, FL 34654-5111
Tel:727-849-9999, x2414 Fax:727-815-3120
WWW.PALL.COM
"Knowledge is power. "
Sir Francis Bacon (1561-1626), Religious Meditations, Of Heresies, 1597
"Dave Shaw" <daveshaw@xxxxxxxxxxxxx>
Sent by: mapics-l-bounces@xxxxxxxxxxxx
02/04/2008 01:54 PM
Please respond to
MAPICS ERP System Discussion <mapics-l@xxxxxxxxxxxx>
To
mapics-l@xxxxxxxxxxxx
cc
Subject
Re: [MAPICS-L] How to debug AMM63?
Peter,
I don't remember whether this program runs interactive or batch, but it
doesn't really matter - there are just a few extra steps with batch.
First off, if you're trying to use STRISDB to debug, my suggestion is to
forget it. It puts stuff in QTEMP that MAPICS happily blows away when it
starts up. There are ways around that, but they're a lot of trouble.
You'll do better with STRDBG or my preference, the WDSCi debugger.
In order to use STRDBG or WDSCi, you have to compile the program with
either OPTION(*SRCDBG) or OPTION(*LSTDBG). Make sure the new one is
highest in your MAPICS library list.
If it's interactive, STRDBG on it, then start MAPICS and go. If it's
batch, submit the job to a held jobq, then STRSRVJOB on it, then release
the queue, STRDBG in the servicing job, and go.
If you'd rather use WDSCi than STRDBG, you have to do the debug setup in
the tool. I don't remember anymore how to do that for an OPM program
(we're all ILE here so I only use SEPs), but it's in both the help and the
tutorial. For batch it's simpler than STRSRVJOB, etc., and for either
it's a much nicer debugger.
Dave Shaw
MAPICS-L moderator
----- Original Message -----
From: "Peter Vidal" <Peter_Vidal@xxxxxxxx>
To: <mapics-l@xxxxxxxxxxxx>
Sent: Monday, February 04, 2008 10:57 AM
Subject: [MAPICS-L] How to debug AMM63?
Hi list:
I need to debug this program. It has a modification that I want to test
and I want to know the best way to debug it running.
Is there a way?
_______________________________________________
This is the MAPICS ERP System Discussion (MAPICS-L) mailing list
To post a message email: MAPICS-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit:
http://lists.midrange.com/mailman/listinfo/mapics-l
or email: MAPICS-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at
http://archive.midrange.com/mapics-l.
--------------------------------------------------------------------------------
Attention:
This communication may contain information that is confidential,
privileged and/or exempt from disclosure under applicable law.
If you are not the intended recipient, please notify the sender
immediately and delete the original, all attachments, and all
copies of this communication.
--------------------------------------------------------------------------------
midrange.com
