Re: Command for Limiting Query to run in Batch only

Rick,

Look in the Appendix of the Query manual.  My V3R1 manual has the
instructions in Appendix D.

The basic solution is to:
"Use the Change Command (CHGCMD) command to remove *INTERACT from the
    ALLOW (where allowed to run) parameter.  ALLOW(*PGM) is not allowed in
    RUNQRY."


Bill

----- Original Message -----
From: <RickCarter@holley.com>
To: <BPCS-L@MIDRANGE.COM>
Sent: Tuesday, March 07, 2000 2:58 PM
Subject: Command for Limiting Query to run in Batch only


>
> In the last week or so, someone responded to a Query issue with BPCS and
> one suggestion was setting a query value where the query would only run in
> Batch mode vs Interactive.
> What is that command
>
>
> +---
> | This is the BPCS Users Mailing List!
> | To submit a new message, send your mail to BPCS-L@midrange.com.
> | To subscribe to this list send email to BPCS-L-SUB@midrange.com.
> | To unsubscribe from this list send email to BPCS-L-UNSUB@midrange.com.
> | Questions should be directed to the list owner: dasmussen@aol.com
> +---


__________________________________________________
Do You Yahoo!?
Talk to your friends online with Yahoo! Messenger.
http://im.yahoo.com

+---
| This is the BPCS Users Mailing List!
| To submit a new message, send your mail to BPCS-L@midrange.com.
| To subscribe to this list send email to BPCS-L-SUB@midrange.com.
| To unsubscribe from this list send email to BPCS-L-UNSUB@midrange.com.
| Questions should be directed to the list owner: dasmussen@aol.com
+---