Re: RDi 9.5 >Selected>Filter Selection. Needs a "Two-Stroke".

I believe that there is an APAR open for this...

Mike

Mike Hockings, M.Eng., P.Eng.
IBM Rational Developer for System z and Power Systems Software Technical
Support
IBM Canada Ltd. Laboratory
hockings@xxxxxxxxxx
voice 1-905-413-3199 T/L 313-3199 ITN 23133199




From: Ken Killian <kkillian@xxxxxxxxxxxx>
To: "Rational Developer for IBM i / Websphere Development Studio
Client for System i & iSeries" <wdsci-l@xxxxxxxxxxxx>
Date: 2015-11-06 16:16
Subject: [WDSCI-L] RDi 9.5 >Selected>Filter Selection. Needs a
"Two-Stroke".
Sent by: "WDSCI-L" <wdsci-l-bounces@xxxxxxxxxxxx>



Hi,

Using RDi 9.5, I am getting Strange behavior on the "Filter Selection"....

1.) Highlight the field
2.) Ctrl+F10 (same as right click)
3.) >Selected>Filter Selection


It does not work, but shows me the message "xxxx occurrences". Perplexed, I
think RDi 9.5 is SLOW...

Wait 1-minute, NOTHING!

Click on the source to try again, and then it "magically" does the Filter.
It works after the "Two-Stroke" or the "click-Twice"...

Previously, this action was almost always "instant"....

I am using the Test Patch from 2015-10-27....

-Ken Killian-


--
This is the Rational Developer for IBM i / Websphere Development Studio
Client for System i & iSeries (WDSCI-L) mailing list
To post a message email: WDSCI-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/wdsci-l
or email: WDSCI-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/wdsci-l.