Debug issues

I thought I’d seen everything the debugger could throw at me but …

Issue Debug - SEP

SEP tab shows up. But program does not appear in list. No error message issued. No error message in logs. Nada!

Try to attach debug to an existing job - everything works exactly as it should - except the debugger does not get fired up.

Start a new 5250 session - attach debugger to that job and specify program details. No errors - no nothing. No debug messages, program when called runs to completion. Again no messages in job log or anywhere else.

This is a brand new instal on a client’s system. Whole bunch of PCs - “works" as normal on some but exhibits the symptoms above on others. ** “works” is an interesting word here because we have yet to have a machine where it all works as it should - but some do at least add the program to the SEP. When the program was called the dialog “Do you want to switch …” was displayed and then RDi went into non-responsive mode. Re-launched - nothing (open source etc.) had been forgotten - but this time the setting of SEP and debug etc. worked perfectly.

These machines are brand new 9.1 installs, show no issues when Test Connection is used, and behave normally for compile etc.

Anyone got any thoughts?


Jon Paris

www.partner400.com
www.SystemiDeveloper.com