Re: RDi will not prompt to load workspace

The setting is always on (in all the workspaces I am using and the default workspace) meaning it (should) will always prompt upon startup.

I basically removed all workspace references I could find from my documents and settings folder and my actual workspace folder and RDi created a new workspace in my documents and settings folder with that preference set.

Thanks, Matt

-----Original Message-----
From: wdsci-l-bounces@xxxxxxxxxxxx [mailto:wdsci-l-bounces@xxxxxxxxxxxx] On Behalf Of Jason Anderson
Sent: Friday, February 12, 2010 9:12 AM
To: Rational Developer for IBM i / Websphere Development Studio Client forSystem i & iSeries
Subject: Re: [WDSCI-L] RDi will not prompt to load workspace

Matt,

I am using RDi 7.5. I have checked the "Use this as the default and do
not ask again" checkbox and am not prompted. As a test, I just went in
to Preferences > General > Startup and Shutdown, checked the "Prompt
for workspace on startup" checkbox, clicked on Apply, clicked on OK,
shut down, and started up.

I was prompted for my workspace. The only thing I can think of is you
did not click Apply. You may want to double check your settings.
Otherwise, to me, your IDE is not working as expected in this regard.

Thank you.
Jason Anderson

On Fri, Feb 12, 2010 at 10:48 AM, Tyler, Matt <matt.tyler@xxxxxxxxxxxxxx> wrote:

Rdi will no longer prompt for the workspace I want to load.  I loads a
default workspace in C:\Documents and Settings\pgmt\IBM.



I set the preference "Prompt for workspace on startup" but that is
ignored.



If I delete the entire IBM folder reference the product creates a new
one for me.



The only way to use the workspace I want it to do a File | Switch
Workspace.



Anyone seen this issue or have a suggestion to make RDi open the
workspace I want?



Thanks, Matt