Re: Can't set service entry point?

If you have over 100 developers all using SEP debugging, you'll get some angry looks if you simply stop and restart the debug server.

Been there, done that (even though there's only 2 of us using WDSC, out of 10 developers).


Peter Colpaert
Software Engineer, Philips Consumer Luminaires

Industrieterrein Satenrozen 11, 2550 Kontich, Belgium
Tel. +32/ 3 450 74 09, Fax +32/ 3 450 74 33, Internal 1317
peter.colpaert@xxxxxxxxxxx, www.philips.com

Simply Switch to printing double-sided and printing less

-----Original Message-----
From: wdsci-l-bounces@xxxxxxxxxxxx [mailto:wdsci-l-
bounces@xxxxxxxxxxxx] On Behalf Of ssc1478
Sent: woensdag 30 september 2009 14:22
To: Websphere Development Studio Client for iSeries
Subject: Re: [WDSCI-L] Can't set service entry point?

On Tue, Sep 29, 2009 at 11:52 PM, Xuan Chen <xuanchen@xxxxxxxxxx>
wrote:

Is it possible someone else has already set the SEP on the program?

Oh, really? That's a limitation? Is there a way to see all SEP's set
on a system? We've got over 100 developers. I could see some of them
set SEP's and forget about removing them.

What you can try is to stop the debug server (ENDDBGSVR) and start

the

debug server again (STRDBGSVR) and try to set SEP again.

Apparently doing this removes all SEP's? That's good to know. The
next time you go into RDi, will the SEP view update or will it still
show the SEP (erroneously.)


Thanks!
Phil
--

The information contained in this message may be confidential and legally protected under applicable law. The message is intended solely for the addressee(s). If you are not the intended recipient, you are hereby notified that any use, forwarding, dissemination, or reproduction of this message is strictly prohibited and may be unlawful. If you are not the intended recipient, please contact the sender by return e-mail and destroy all copies of the original message.