Proper was to end debug with SEP

Last week I submitted a post targeted to the developers. It started out 
with the following:

While debugging an RPGLE program (using SEP), if I get to a point in my 
program where I want to terminate the RPG, I use sys-req(2) to cancel the 
job and then click on the red terminate button in the Debug view. Then 
when I try to edit the RPG in RSE, I get a window that pops up saying 
"Unable to create part".

Today, twice, I've had to reboot my pc to enable using the SEP debugger 
effectively. In both instances I'm debugging a decimal data error or a 
start position out of range error, and it seems that after the first time 
the error occurs, and I get the error on my green screen where the program 
is running, after I respond to dump or cancel, I terminate the debug 
session. I then try to restart the debug session, however when I restart 
the RPG program, to run it through the debugger again to get a better idea 
of what is happening, the debugger doesn't initialize itself correctly 
(meaning it doesn't start at the first executable statement in the 
program). The program justs runs until the error occurs and the debugger 
never kicks in. I didn't change anything regarding the SEP, and didn't 
recompile the program either. Other than a reboot I can't figure out how 
to 're-initialize' the debug session. I even try by removing the SEP and 
then readding it, but the same problem persists.

So my question is, is there any preferred method of terminating a debug 
session when an error occurs? Should the SEP session be ended before the 
program? Or should the program end before the debugger? Does it make a 
difference?

The other weird behavior is that after terminating the debug session 
(using a custom debug perspective), all the view tabs used by debug show 
up in my RSE perspective. It's very confused :(

PS - This is the full WDSCi with all current patches and updates.

Regards, Jerry

Gerald Kern - MIS Project Leader
Lotus Notes/Domino Administrator
IBM Certified RPG IV Developer
The Toledo Clinic, Inc.
4235 Secor Road
Toledo, OH 43623-4299
Phone 419-479-5535
gkern@xxxxxxxxxxxxxxxx


This e-mail message, including any attachments, is for the sole use of the 
intended recipient(s) and may contain confidential and privileged 
information. Any unauthorized use, disclosure or distribution is 
prohibited. If you are not the intended recipient, please inform the 
sender by reply e-mail and destroy this and all copies of this message.