RE: Where is verify connection in 6.x

Xuan:

Version V5R2M0

RPG IV, Debug as...

None of the breakpoints have tails.

Duane Christen



-----Original Message-----
From: Xuan Chen [mailto:xuanchen@xxxxxxxxxx]
Sent: Wednesday, December 07, 2005 11:07 AM
To: Websphere Development Studio Client for iSeries
Subject: RE: [WDSCI-L] Where is verify connection in 6.x


Hi Duane,

Could you please provide me the following information?

iSeries Version
Language of the program/service program you want to debug
The steps you used to start your debug session (setting Service entry
point, or Debug as ...)
And also please check if the breakpoint you set in the procedure is just a
blue dot, or has a check mark on top of it (looks like it has a little
tail).

Thanks,

Xuan Chen,  Problem Determination Tools for iSeries
(905) 413-3769 T/L 969-3769
xuanchen@xxxxxxxxxx




                                                                           
             "Christen, Duane                                              
             J."                                                           
             <dchristen@mcleod                                          To 
             usa.com>                  "'Websphere Development Studio      
             Sent by:                  Client for  iSeries'"               
             wdsci-l-bounces@m         <wdsci-l@xxxxxxxxxxxx>              
             idrange.com                                                cc 
                                                                           
                                                                   Subject 
             12/07/2005 11:16          RE: [WDSCI-L] Where is verify       
             AM                        connection in 6.x                   
                                                                           
                                                                           
             Please respond to                                             
                 Websphere                                                 
                Development                                                
             Studio Client for                                             
                  iSeries                                                  
                                                                           
                                                                           




WDSC 6.0.1 Build id: 20050725_1800

I am attempting to debug a process with multiple service programs and
underlying procedures. In the previous version of WDSC (5.1...) I could set
breakpoints within the lower lever procedures and click the resume
button/F8
and the process would stop on the break point in the lower level proc. With
WDSC 6.0.1 the break points are ignored, unless I step into the procedure
and then click resume/F8. Is there a "run to next breakpoint" or something
else that I am missing?

It is a real PITA having to step into 4 procedures just to get down to
where
I need to debug the process.

Duane Christen


P.S. The step over button/F6 function is also ignoring breakpoints which is
less of a problem but is still entirely unexpected.





NOTICE: This electronic mail transmission may contain confidential
information and is intended only for the person(s) named.  Any use, copying
or disclosure by any other person is strictly prohibited. If you have
received this transmission in error, please notify the sender via e-mail.



--
This is the Websphere Development Studio Client for iSeries  (WDSCI-L)
mailing list
To post a message email: WDSCI-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/wdsci-l
or email: WDSCI-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/wdsci-l.