Re: WDSC 6.0 After install error opening member

This might seem a bit defeatist, but based on the problems I encountered
trying to migrate a V5.1.2 workspace, just create a new workspace under
V6.0 and import your projects from your old workspace.

If you have time to work with this, maybe someone else on the list will
have more "positive" suggestions on migration.

regards


James O'Sullivan
Senior Technical Consultant
email: josulli4@xxxxxxx
Office: +44 1252 536681
Fax: +44 1252 534022
www: www.csc.com
Based at: Tower 2, Floor 2, Royal Pavilion, Wellesley Road, Aldershot,
Hampshire, GU11 1PZ

CSC Corporation Limited: No. 1812179.
All registered office addresses: Royal Pavilion, Wellesley Road, Aldershot,
Hampshire, GU11 1PZ. Registered in England.
________________________________________________________________________________________

This is a PRIVATE message. If you are not the intended recipient, please
delete without copying and kindly advise us by e-mail of the
mistake in delivery. NOTE: Regardless of content, this e-mail shall not
operate to bind CSC to any order or other contract unless
pursuant to explicit written agreement or government initiative expressly
permitting the use of e-mail for such purpose.
________________________________________________________________________________________


                                                                           
             jstevens@mizehous                                             
             er.com                                                        
             Sent by:                                                   To 
             wdsci-l-bounces@m         wdsci-l@xxxxxxxxxxxx                
             idrange.com                                                cc 
                                                                           
                                                                   Subject 
             18/08/2005 16:45          [WDSCI-L] WDSC 6.0 After install    
                                       error opening member                
                                                                           
             Please respond to                                             
                 Websphere                                                 
                Development                                                
             Studio Client for                                             
                  iSeries                                                  
             <wdsci-l@midrange                                             
                   .com>                                                   
                                                                           
                                                                           




I installed 6.0 - every one's right - it take a looong time.

I saved my workspace before and replaced the workspace in 6.0.  (Did that
after it started up the first time.) ie - I saved the new workspace, then
put the old workspace in place if the new one.  Hope that's not my
problem.

Anyway, all of my filters, etc were there when I open 6.0 up.  But
whenever I try to open a source member in the LPEX editor, I get an
"Operation Failed. File system input or output error", with the details
saying...

Message reported from file system: Resource
/RemoteSystemsTempFiles/DELTA/QSYS.LIB/REPRICE.LIB/QSRC.FILE/FR0030.CLLE
does not exist..

I tried clearing my cache in Prefernces.Remote Systems.iSeries, but that
had no effect.

Any suggestions?

TIA!





Jeff Stevens
Mize, Houser & Co. P.A.
913 451 1882
JStevens@xxxxxxxxxxxxxx

--
This is the Websphere Development Studio Client for iSeries  (WDSCI-L)
mailing list
To post a message email: WDSCI-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/wdsci-l
or email: WDSCI-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/wdsci-l.