Re: Problem debugging with SEPs

Robb,

This is a known problem with Service Entry Point, and it will be addressed
in the next release of WDSc.

For now, there is a work around.  Go to the right top corner of Service
Entry Point view, click on the drop down arrow there, and then click Clear
all service entry points.  Then Set the service entry point again.

Thanks,

Xuan Chen,  Problem Determination Tools for iSeries
(905) 413-3769 T/L 969-3769
xuanchen@xxxxxxxxxx




                                                                           
             robbin.knapp@artw                                             
             eger.at                                                       
             Sent by:                                                   To 
             wdsci-l-bounces@m         wdsci-l@xxxxxxxxxxxx                
             idrange.com                                                cc 
                                                                           
                                                                   Subject 
             06/29/2005 01:51          [WDSCI-L] Problem debugging with    
             AM                        SEPs                                
                                                                           
                                                                           
             Please respond to                                             
                 Websphere                                                 
                Development                                                
             Studio Client for                                             
                  iSeries                                                  
                                                                           
                                                                           





After debugging then recompiling we have to end WDSc before debugging the
same program again.

We followed Jef Sutherland's tip in the May 2005 _iSeries News_ by ending
the SEP, then recompiling the program, then setting the SEP again.
Everything looks fine up to this point. The SEP is listed in the SEP view,
but the program runs to completion without debugging.

If we remove and re-set the SEP without recompiling, the debugging works
fine, but when we recompile, we have to end and restart WDSc before the
debugging will work.

We are using the German-language version of WebSphere Development Studio
Client for iSeries Version 5.1.2.4 with all the latest updates with Windows
XP Professional Version 2002 Service Pack 2, also with all the latest
updates.

Has anyone else encountered this problem? I haven't been able to find it
anywhere else.

Thanks.

-Robb
Robbin D. Knapp, IT
Artweger GmbH. & Co., Sulzbach 159, 4820 Bad Ischl, Austria
Tel. +43 6132 205-48, Fax +43 6132 205-102
http://www.artweger.at--
This is the Websphere Development Studio Client for iSeries  (WDSCI-L)
mailing list
To post a message email: WDSCI-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/wdsci-l
or email: WDSCI-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/wdsci-l.