Did you add the new procedure to the binder language member of the service
program?
Mit freundlichen Grüßen / Best regards
Birgitta Hauser
"Shoot for the moon, even if you miss, you'll land among the stars." (Les
Brown)
"If you think education is expensive, try ignorance." (Derek Bok)
"What is worse than training your staff and losing them? Not training them
and keeping them!"
-----Ursprüngliche Nachricht-----
Von: RPG400-L [mailto:rpg400-l-bounces@xxxxxxxxxxxx] Im Auftrag von Alan
Cassidy
Gesendet: Tuesday, 26.8 2014 17:13
An: RPG programming on the IBM i (AS/400 and iSeries)
Betreff: RE: Exported Procedures not showing up in DSPMOD but show
asexported in DSPSRVPGM
Correction!
In the DSPMOD display, the new procedures DO show up in the "Procedure list"
screen, but NOT in the "Exported defined symbols" screen.
If it makes any difference, the source for both of these two procedures are
the only ones in "fully-free" RPG without any column-dependent code at all.
Alan Cassidy
Software Engineer II
Hospital Physician Partners
954-693-0000 ext. 3433 - Direct phone
786-380-9236 - Mobile phone
acassidy@xxxxxxxxxxxxxx<mailto:acassidy@xxxxxxxxxxxxxx>
www.hppartners.com<
http://www.hppartners.com>
[HPP Logo FINAL with name-tag-logo-TM]
----------------------------------------------------------------------------
----
Confidentiality Notice: This email may contain confidential information or
information covered under the Privacy Act, 5 USC 552(a), and/or the Health
Insurance Portability and Accountability Act (PL 104-191) and its various
implementing regulations and must be protected in accordance with those
provisions. It contains information that is legally privileged, confidential
or otherwise protected from use or disclosure. This e-mail message,
including any attachments, is for the sole use of the intended recipient(s).
Any unauthorized review, use, disclosure or distribution is prohibited. You,
the recipient, are obligated to maintain it in a safe, secure and
confidential manner. If you are not the intended recipient, please contact
the sender by reply e-mail and destroy all copies of the original message.
Thank you.
----------------------------------------------------------------------------
----
--
This is the RPG programming on the IBM i (AS/400 and iSeries) (RPG400-L)
mailing list To post a message email: RPG400-L@xxxxxxxxxxxx To subscribe,
unsubscribe, or change list options,
visit:
http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives at
http://archive.midrange.com/rpg400-l.
midrange.com
