×
The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.
On 2/2/2011 11:08 AM, David FOXWELL wrote:
Vern, the error ocurred in a linear Main program. The program started
again. Then, doesn't 'G' mean go to the beginning of next cycle?!
David, are you saying that you got an RPG inquiry message for an error
in a linear main program? That's not supposed to happen. The RPG
inquiry messages are issued by the "Default Error Handler" which is only
in effect for cycle-main procedures.
If the 'G' was for an inquiry message put up by a CL program and it
called your linear main program, then it's a different story. In that
case, the linear main program would start again, at the beginning of the
main procedure.
If the G' was for an inquiry message put up by another RPG cycle-program
that called your linear main program, then Vern's (and my) concern about
the 'G' response still stands for that other program.
In any case, ou may need to add some exception handling or cancel
handling to your linear main program so it can close files etc. no
matter how it ends.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact
[javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
