Are you files keyed logicals ?
On SETLL *LOVAL repositions at the start of a keyed file *START repositions at the start of a non-keyed file
On SETGT *HIVAL repositions at the end of a keyed file *END repositions at the end of a non-keyed file
-----Original Message-----
From: rpg400-l-bounces@xxxxxxxxxxxx [mailto:rpg400-l-bounces@xxxxxxxxxxxx] On Behalf Of OPLink
Sent: Wednesday, December 05, 2007 7:16 PM
To: RPG programming on the AS400 / iSeries
Subject: SETGT *End/*Start
We are on 5.3 and I can not use the *END or *START
with SETGT as shown below. In SEU the error message
RNF5318 pops up when enter is pressed. I can not find any
docs on the cause of error or that I can even use the *START/*END
with SETGT. However, they both work fine for SETLL.
Am I missing a PTF??
thanks
JoeM
-----------------------------------
C *START SETGT ITEMBL
Factor 1 entry has a data type that is not allowed for this operation; speci...
-----------------------------------
F1 on message line
-----------------------------------
Additional Message Information
Message ID . . . . . . : RNF5318 Severity . . . . . . . : 30
Message type . . . . . : Diagnostic
Message . . . . : Factor 1 entry has a data type that is not allowed for
this operation; specification is ignored.
Cause . . . . . : The Factor 1 entry (positions 12 - 25) must have the
correct data type.
Recovery . . . : Correct the Factor 1 entry (positions 12 - 25). Compile
again.
--
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit:
http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at
http://archive.midrange.com/rpg400-l.
midrange.com
