RE: STRPCCMD and AcroRd32 Questions

There is a parm on the STRPCCMD called PAUSE() which normally defaults to
*YES. This makes the dos window remain open...

-----Original Message-----
From: rpg400-l-bounces@xxxxxxxxxxxx
[mailto:rpg400-l-bounces@xxxxxxxxxxxx]On Behalf Of
nickmart@xxxxxxxxxxxxxxx
Sent: Wednesday, October 17, 2007 9:01 AM
To: rpg400-l@xxxxxxxxxxxx
Subject: STRPCCMD and AcroRd32 Questions


Thanks to this list and a thread from October 2004, I was able to use the
STRPCCMD to print a PDF document using the input switches of /p and /h. I
am using the following the STRPCCMD PCCMD parameter: start acrord32.exe /p
/h i:\documentname.pdf.

The Adobe Reader will open up the document and print it just fine.
However, the application window stays open.

Is there another input switch I can use in the command to close the
application when finished printing?

Also, could anyone point me toward a reference of sorts to input switches?

Thank you in advance.

Nick W. Mart

--
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.




--
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.