Re: Problem w/ calling a multi-members file

It's a file not found error - check your file name. If you're specifying a
variable for the file name, make sure it's correct. If it's a hard coded
file name, check your F spec.

On 5/30/06, steema@xxxxxxxxxxxxx <steema@xxxxxxxxxxxxx> wrote:

HI if you recall, I have to find the comments for a repair in a file that
is multi - member. the name of the member, is the invoice number, which I
can get from the main file or via the subfile. what is very strange is
that the called program, seems to kick off w/out any logic. I have a debug
break on the call statement, but it still kicks off w/ this error message:

Perhaps someone has seen this before.


Message ID . . . . . . :   RNX1216       Severity . . . . . . . :   99
Message type . . . . . :   Diagnostic
Date sent  . . . . . . :   05/30/06      Time sent  . . . . . . :
09:05:19

Message . . . . :   Error message CPF4102 appeared during OPEN for file
  REPAIRS.
Cause . . . . . :   RPG procedure OERRPRM in program MYLIB/OERRPRM
received
  the message CPF4102 while performing an implicit OPEN operation on file
  REPAIRS. The actual file is REPAIRS.
Recovery  . . . :   Check the job log for a complete description of
message
  CPF4102, and contact the person responsible for program maintenance. If
the
  file has a device type of SPECIAL, there may be no message in the job
log.

--
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.