ILE and Access Paths

As a matter of fact Rob, this subprocedure is called over and over.  That
was my problem with doing the LR.  My goal is to have the files closed when
I am completely done calling the sub procedure.  I leave the activation
group as the default on the CRTPGM.  Your guidance is apprececiated.

------------------------------

message: 9
date: Fri, 4 Nov 2005 09:55:55 -0500
from: rob@xxxxxxxxx
subject: Re: ILE and Access Paths

It depends.
Is this subprocedure called multiple times?  Then setting on LR may
adversely affect performance.

For example
MyCLpgm
..calls Pgm1
....calls pgmA
......calls subprocedure several times
..calls Pgm2
Then setting on LR, or the use of OPEN/CLOSE, or even ending that new
activation group, might be good when the step that calls the subprocedure
multiple times is done running.


Rob Berendt
--
Group Dekko Services, LLC
Dept 01.073
PO Box 2000
Dock 108
6928N 400E
Kendallville, IN 46755
http://www.dekko.com





JMBauman@xxxxxxxxxxxxxxxx
Sent by: rpg400-l-bounces@xxxxxxxxxxxx
11/04/2005 08:11 AM
Please respond to
RPG programming on the AS400 / iSeries <rpg400-l@xxxxxxxxxxxx>


To
rpg400-l@xxxxxxxxxxxx
cc

Fax to

Subject
ILE and Access Paths






I am fairly new to ILE and have recently created my first sub-procedure.
Yesterday, I had a program that referenced this sub-procedure, run within
a
job stream.  This job stream is a CL job that calls program after program.
Anyway after the program that referenced the sub-procedure ran, the two
files used within the sub-procedure stayed open under QILE.  What can I do
to avoid this in the future?  Should I set on LR in my subprocedure before
I RETURN?  Any help would be appreciated?

Thanks
John M. Bauman
 MIS Manager
 Ward Trucking
 Second Avenue & Seventh Street, Greenwood
 Altoona, PA 16603

 Direct Voice (814) 947-1284
 Fax (814) 944-5470
 www.wardtrucking.com