Re: work files in qtemp

Suffice to say Larry, post it to the list man lol.  Looks like everyone 
wants a copy.

Ron Power
Programmer
Information Services
City Of St. John's, NL
P.O. Box 908
St. John's, NL
A1C 5M2
Tel: 709-576-8132
Email: rpower@xxxxxxxxxx
Website: http://www.stjohns.ca/
___________________________________________________________________________
Success is going from failure to failure without a loss of enthusiasm. - 
Sir Winston Churchill




Dennis Nel <dvnel.za@xxxxxxxxx> 
Sent by: rpg400-l-bounces@xxxxxxxxxxxx
18/05/2005 04:10 AM
Please respond to
RPG programming on the AS400 / iSeries <rpg400-l@xxxxxxxxxxxx>


To
RPG programming on the AS400 / iSeries <rpg400-l@xxxxxxxxxxxx>
cc

Subject
Re: work files in qtemp






I would like a copy of the source for these commands, thanks!

On 5/17/05, Larry Ducie <Larry_Ducie@xxxxxxxxxxx> wrote:
<snip>
> The commands I wrote are:
> STRJOBCMD - here you specify the job you want to take control of.
> SNDJOBCMD - here you send a command to that job. You can send as many as 
you
> want.
> ENDJOBCMD - here you release control.
> 
> I still use them when servicing a batch job and debugging it. If I get 
to a
> point where I want to see what's in a file in QTEMP I simply send a 
command
> to CPYF it into a production library. I can even amend the data and cpyf
> (*replace) it back again. All this while sitting on a break point! Boy 
does
> that make life easier.
> 
> Anybody who wants the source are most welcome. I'll even post the whole 
lot
> on the list if it's something that might be of use to people - but 
believe
> me, there is nothing to these programs.
<end-snip>

-- 
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.