Re: Debug

STRDBG PGM(*LIB/*PGM)

Once in the source set your break point.

Press F12 to resume.

You will be dropped to the command line.  Call your CL program and voila. 
You should get to your breakpoint.

HTH,

Ron Power
Programmer
Information Services
City Of St. John's, NL
P.O. Box 908
St. John's, NL
A1C 5M2
Tel: 709-576-8132
Email: rpower@xxxxxxxxxx
Website: http://www.stjohns.ca/
___________________________________________________________________________
Success is going from failure to failure without a loss of enthusiasm. - 
Sir Winston Churchill




"Anita Imbrescia" <aimbresc@xxxxxxxxxxxxxxxxxxxxx> 
Sent by: rpg400-l-bounces@xxxxxxxxxxxx
11/02/2005 01:10 PM
Please respond to
RPG programming on the AS400 / iSeries <rpg400-l@xxxxxxxxxxxx>


To
"'RPG programming on the AS400 / iSeries'" <rpg400-l@xxxxxxxxxxxx>
cc

Subject
Debug






When I used STRISDB, I used to debug the program and invoke program =
*no, then I could call a cl and it would debug the program.  Can someone
tell me how I do that in STRDBG using ILE?  Thank you in advance.

Anita Imbrescia
Westmoreland County Information Systems
aimbresc@xxxxxxxxxxxxxxxxxxxxx



-- 
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.