RE: CHAIN & Operation Extender

["DeLong, Eric" <EDeLong@xxxxxxxxxxxxxxx>]

Buzz, check your syntax.  Operation extenders go on the opcode, not factor
2.

Eric DeLong
Sally Beauty Company
MIS-Project Manager (BSG)
940-898-7863 or ext. 1863



-----Original Message-----
From: Buzz Fenner [mailto:bfenner@xxxxxxxxxxxxxxxx]
Sent: Tuesday, September 16, 2003 3:46 PM
To: RPG Discussion
Subject: CHAIN & Operation Extender


I've tried to code a simple CHAIN operation without a record lock (code does
a lock later) and I cannot get the thing to compile.  Here's the code:

Fglmstrl1  uf   e           k disk

Plus any of the following:

C
C     frmact        chain     glmstrl1(n)
C                      if           %found
C
C     frmact        chain     glmstrl1 (n)
C                      if           %found
C
C     frmact        chain     glmstrl1(N)
C                      if           %found
C
C     frmact        chain     glmstrl1 (N)
C                      if           %found


Every time, the compiler treats it as an invalid array definition.

*RNF7030 30    188 004400  The name or indicator N is not defined.
*RNF5064 20    188 004400  An array index is specified for name that is not
an array.

I'm using CODE/400, but if I go back to SEU, the same thing happens.  I must
be rustier than I thought.

Buzz Fenner
Systems Analyst/Network Administrator
Phone: 870.930.3374
Fax: 870.930.3376
bfenner@xxxxxxxxxxxxxxxx


_______________________________________________
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.