Re: HMC and Service Processor issue - can't access the HMC

Hey Paul

Some more info might help. What are you seeing n the HMC - does it say
"connecting" or something else ? When you replaced the cables are you sure
they are direct between the correct HMC interface and the 570 ? Do you
happen to have access to the ASMI ? Not sure powering down the 570 will
"reset the FSP" of itself - more action might be needed.

give me a buzz or drop me a line directly if you need a hand.

On Wed, May 11, 2016 at 2:22 PM, PaultinNZ <paultormey@xxxxxxxxx> wrote:

We have a connection problem with our HMC Console and we can’t see any
managed LPARs on our 570.

We have restarted the HMC and replaced the cables, and the next step is to
power down the 570 which will reset the Service Processor.


However if that doesn’t work and the HMC still can’t see the LPARs, is
there a way to power them on without an HMC? Can we use the control panel
on the front?


​Any advice gladly taken.​

--
Paul Tormey
3/11 Bramley Drive
Farm Cove
Auckland
2012
New Zealand
Home: 09 576 3415 or 0064 9 576 3415
Mobile: 021 810615 or 0064 21810615
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.

Please contact support@xxxxxxxxxxxx for any subscription related
questions.