× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.


  1.  Home
  2. MIDRANGE-L
  3. October 2015

Re: Configure NIC port

I usually start with:
WRKHDWRSC *CMN

find the card and you will see the resource names assigned to the ports.

CRTLINETH for the port without a configuration attached to it. If it is plugged into a network device(switch,router) when you vary it on its status should show VARIED ON

as an aside, assuming the console port is LAN CONSOLE, I have created a line description that documents its use as console with ONLINE(*NO).

bryan




Justin Taylor wrote on 10/15/2015 9:04 AM:
I have a POWER7 with a quad port NIC. One is the console port, and two are set up for a Virtual IP line. I've been asked to configure the fourth port. I've never done that before. I checked Info Center, but I must know the proper question to ask. Can someone throw me a bone?


Thanks


As an Amazon Associate we earn from qualifying purchases.

This thread ...
Follow-Ups:
Replies:
Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.