Re: How to get workstations to log on through QPGMR subsystem.

Daryl,
Check the workstation name entries in QPGMR. There is a value for Control
Job At. If this value is *ENTER, you must manually transfer you job to the
susbystem using TFRJOB.
Also, check the QINTER subsystem for workstation type entries. There may
be a generic entry for control job at *SIGNON. In this case, since QINTER
is normally started before QPGMR, it will get you device. You may want to
put a workstation name entry in QINTER for your MIS* with a value of *ENTRY
and make the QPGMR entry at *SIGNON.

Jeff Young
Sr. Programmer Analyst

On Mon, Aug 31, 2015 at 11:53 AM, Darryl Freinkel <dhfreinkel@xxxxxxxxx>
wrote:

We have a need to switch some workstations to run under QPGMR so that we
can shutdown QINTER for a few hours for system maintenance.

I do have workstation entry names in QPGMR with the value MIS*.

That does work occasionally, but I don't remember how and when. My client
access session name is MIS_d1, but it continually goes directly to QINTER.

I want to test the process before this coming weekend.

Help!

TIA

Darryl.
Sent from my iPad
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.