5901s? Oops. Those have no cache so there's your performance problem,
then add the 10K RPM drives and turtle sounds about right. :-(
- Larry "DrFranken" Bolhuis
On 1/8/2014 10:52 PM, Steinmetz, Paul wrote:
Kirk,drawer, with paired 5913 located in a 5877 PCI drawer .
I'm running 18 - 177GB SSD for production, located in a 5887 disk
Also running 24 - 571 10K for R&D, located in a 2nd 5887 disk drawer,with a 2nd pair of 5913 located in a 2nd 5877 drawer.
3RD LPAR 8 571 10K for Upgrade LPAR, located in the CEC, Dual 5901Raided.
I'm configured with dualGX++ buses for redundancy.(if drawer fails, the pair will not)
With the dual buses, the 5913 pair is located in opposite 5877 drawers,
On a 5913, the SSD and 10K could reside on the same 5913, in the samedrawer, but not recommended.
Running SSD off the CEC controller was also not recommended, not enoughcache on the CEC controller
Also, the CEC is not hot swappable, so not using any of the CEC PCI.midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Kirk Goins
My Production LPAR screams with the SSD.
R&D is 4 times slower with the 10k drives.
LPAR 3, 10k with 5901, is like a turtle.
Hope this helps.
From: midrange-l-bounces@xxxxxxxxxxxx [mailto:
Sent: Wednesday, January 08, 2014 10:21 PMSSDs.
Subject: SSDs on Power7
Power7 E4C 6core running 7.1...
Requirement nothing in the CEC that uses a Cache Battery or Say Internal
same expansion chassis as HDDs? Best I can tell when running IBM i if I
Iis there any controller/chassis config that allow SSDs to exist in the
want to run SSDs out side of the CEC I need to A. Dedicate a pair of say
5805's and a 5887 for SSDs Only B. Use say a 5913 and use 1 5887 for SSDs
and a 2nd 5887 for HDDs
list To post a message email: MIDRANGE-L@xxxxxxxxxxxx To subscribe,
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-lmoment to review the archives at http://archive.midrange.com/midrange-l.
or email: MIDRANGE-L-request@xxxxxxxxxxxx Before posting, please take a
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
This mailing list archive is Copyright 1997-2014 by MIDRANGE dot COM and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available here. If you have questions about this, please contact