Configuration is required for the VPN client on your PC, usually by the
system administration group or they give you the host name/ip address
information and instructions on how to configure it yourself.
After the client is properly configured, you must login to the VPN client on
your PC and start a session with the host system. Once the VPN connection
is established, it is like your PC is on their local network and you can
then open the IBM i applications and get connected to the IBM systems.
"Booth Martin" wrote in message
I suspect I am about to look like an idiot again. No big deal. I am
used to it.
Is there a tutorial or instructions on how to connect with VPN?
I have Client Access, iSeries Navigator, and RDi. I have used VPN with
Client access but that setup was in 2009 and I have no idea how I did it
The VPN I am trying to use to connect is: SHREW SOFT VPN CLIENT That
installed, and it shows as connected when I start it. But I can't
figure out what to do next.