MIDRANGE dot COM Mailing List Archive



Home » MIDRANGE-L » April 2013

Re: Replacing a LAN console



fixed

John, I find it strange. Lan console is a PITA sometimes, but not THAT much.
Remember a few critical points:
Each and everyone of the PCS you choose to be Lan Console create their own
certificates and must use separate QCONSOLE devices.
Therefore, if you have access (even for a while) to a working console i
recommend you go to the DST and create a bunch of QCONSOLE with default
passwords.
Then it should only be a matter of creating a connection, using one of
those new qconsole devices and it should work.
You cant share qconsole devices and i believe neither you can share IP
addresses.
Give it a try.

Best Regards,

Roberto


On Mon, Apr 15, 2013 at 7:58 PM, John McKee <jmmckee@xxxxxxxxxxxxxx> wrote:

Today was another headscratcher. Still does not work. I performed a
dump for Tony and sent it to him. One issue that sticks out is
difficulty with port 3001. I can't help but wonder if I failed to
properly install something. I can't recall the option I selected for
the install. Could a missing piece cause a problem with port 3001?
There is no firewall on the pc and there are no port restrictions on
the network. This morning, the old dying pc was started and it
worked. Then, I removed the network cable from the old pc and
attached it to the new pc. Same IP address and net mask for both
computers. Thus my wondering if I selected the wrong option or needed
to install something else.

Anthony wants me to install CA on a laptop and connect to connector
T5. Purpose is to prove the network is not the issue. But, this is
the same network cable, just moved from one computer to another.

Any ideas?

John McKee

On Fri, Apr 12, 2013 at 9:30 AM, Jack Kingsley <iseriesflorida@xxxxxxxxx>
wrote:
I will add this, if your going to use multiple PC's, then make sure you
are
establishing some guidelines as it pertains to the usage of QCONSOLE and
service tools device ID's by PC.


On Fri, Apr 12, 2013 at 9:31 AM, Jerry C. Adams <midrange@xxxxxxxx>
wrote:

Rob is right; you need more than one device (PC) with LAN console
ability,
and it isn't necessary to IPL the System i to do this or to set it to
dedicated mode.

Personally I have a very bad memory so I documented all of the steps.
If
you need/want copies, email me off-list.

Jerry C. Adams
IBM i Programmer/Analyst
Who the hell was that? -Winston Churchill after Frank Sinatra had come
up
and shaken his hand.
--
Home Office: 615-832-2730
email: midrange@xxxxxxxx


-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of John McKee
Sent: Thursday, April 11, 2013 2:19 PM
To: Midrange Systems Technical Discussion
Subject: Re: Replacing a LAN console

I forgot one other little detail. Currently, the new and old broken LAN
consol pcs are in a room next to the room containing the i.
Despite the detail that a ping from one to the other works, he wanted
me to
move the pc into the room with the i, and directly attach to connector
T5.
Light in that room isn't the best. Used to be a flashlight there as
well.
I could not find a T5 connector. This was to rule out a network issue.
But, network worked just fine until original LAN console pc died. Did
his
suggestion have merit?

John McKee

On Thu, Apr 11, 2013 at 2:02 PM, <rob@xxxxxxxxx> wrote:
Yeah, IPLing your IBM i to resolve a console issue, and then find out
you still don't have a functioning console, is one sure way to muff up
your Monday.


Rob Berendt
--
IBM Certified System Administrator - IBM i 6.1 Group Dekko Dept 1600
Mail to: 2505 Dekko Drive
Garrett, IN 46738
Ship to: Dock 108
6928N 400E
Kendallville, IN 46755
http://www.dekko.com





From: John McKee <jmmckee@xxxxxxxxxxxxxx>
To: Midrange Systems Technical Discussion <
midrange-l@xxxxxxxxxxxx>,
Date: 04/11/2013 02:52 PM
Subject: Re: Replacing a LAN console
Sent by: midrange-l-bounces@xxxxxxxxxxxx



There is a pc in the computer room. Only has 5250 emulation on it.
When the mess happened before, it was sufficient, barely, to resolve
that issue. Boss said there would be no backup or IPL this weekend,
to avoid a potential additional headache. The headache of the
unknown.

John McKee

On Thu, Apr 11, 2013 at 1:22 PM, Jerry C. Adams <midrange@xxxxxxxx>
wrote:
If your boss doesn't like complications, he should love the
multi-console
capability that Rob mentioned. We had three [3] PCs capable of being
the
console at a previous employer. My boss or I could start a process
on
the
console and the other one would take it over right in the middle.
Easy.
The third PC was, as Rob mentioned, mostly for backup (or because I
was
in
the CFO's office one day and didn't want to walk to the other side of
the
building to access the console, I forget).

Short of an HMC, this is the best option available.

Jerry C. Adams
IBM i Programmer/Analyst
I think that the free-enterprise system is absolutely too important
to
be
left to the voluntary action of the market place. - Congressman
Richard Kelly (FL)
--
Home Office: 615-832-2730
email: midrange@xxxxxxxx


-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of John McKee
Sent: Wednesday, April 10, 2013 2:01 PM
To: Midrange Systems Technical Discussion
Subject: Re: Replacing a LAN console

I gathered I could, based on the screen inquiring if I wanted to take
control. Issue then becomes a matter of communication. The system
is almost totally unmonitored. No dedicated people to serve as
"operators".
So even knowing who will be operating is a bit of a challenge.

The boss would not want to complicate things too much. He also
functions as
an operator every other weekend doing backups. It is all very
strange.
But, this is on a prolonged death spiral. May be running another
year.

I was wondering about the sequence of buttons I pushed to clear
"something"
on the i that prevented the current console from connecting after I
trashed
the config and rebuilt it exactly as it was. Whay was that an issue?
What
was going on? Will multiple consoles cause a repeat? The last is
important
especially since I have no idea who will be using the console.

John McKee

On Wed, Apr 10, 2013 at 1:50 PM, <rob@xxxxxxxxx> wrote:
Did you know that you can have more than one device be your Lan
Console? I strongly recommend loading it on more than one PC. This
way if one dies, you can use the other. Or, if you're a two person
IT shop, load it on both you and your coworker's laptop.
Granted, with HMC, it's been awhile since I've used Lan Console.


Rob Berendt
--
IBM Certified System Administrator - IBM i 6.1 Group Dekko Dept 1600
Mail to: 2505 Dekko Drive
Garrett, IN 46738
Ship to: Dock 108
6928N 400E
Kendallville, IN 46755
http://www.dekko.com





From: John McKee <jmmckee@xxxxxxxxxxxxxx>
To: Midrange Systems Technical Discussion
<midrange-l@xxxxxxxxxxxx>,
Date: 04/10/2013 02:43 PM
Subject: Replacing a LAN console
Sent by: midrange-l-bounces@xxxxxxxxxxxx



I used the wrong term last week. It was NOT an OPS console. It is
LAN console.

After getting the thing to work last week, I come in this morning to
see that the thing had died. I don't know why it needed to be
rebooted, but Windows had a problem finding a DLL. Many reboots
later, I saw that different pieces were mysteriously "missing".

For the moment, it is working. It is an MPC. Looks like a bloated
LCD display, but it is computer built into a monitor. I tried to
get into BIOS setting, with intent of running SpinRite. I believe I
will pass on that.

Boss wants it replaced, and there is a much newer computer
available.

Point of this post, if somebody reading this has not given up, is
confusion I have. After I deleted the LAN configuration from the
pc, which Windows had no problem doing, I built a new console , per
request from IBM. Initially, Windows would not allow the new
configuration to be stored. Had no issue with me deleting a
configuration. Seems odd. But, anyway, new configuratio was
finally stored. Console would not connect to the i. But, this
time, an error popped up which Tony knew how to fix. It involved
going to the i front panel and entering a number of codes. I can't
remember what they were. Seem to remember one sequence being
repeated maybe eight times.

Ok, during start of the current LAN console, there is a point where
the option to take control is presented.

My issue is what the heck was I clearing on the i and is that a
factor in replacing the console computer?

John McKee
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L)
mailing list To post a message email: MIDRANGE-L@xxxxxxxxxxxx To
subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx Before posting, please
take a moment to review the archives at
http://archive.midrange.com/midrange-l.


--
This is the Midrange Systems Technical Discussion (MIDRANGE-L)
mailing list To post a message email: MIDRANGE-L@xxxxxxxxxxxx To
subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx Before posting, please
take a moment to review the archives at
http://archive.midrange.com/midrange-l.

--
This is the Midrange Systems Technical Discussion (MIDRANGE-L)
mailing
list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx To subscribe,
unsubscribe,
or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx Before posting, please
take
a moment to review the archives at
http://archive.midrange.com/midrange-l.


--
This is the Midrange Systems Technical Discussion (MIDRANGE-L)
mailing
list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx To subscribe,
unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx Before posting, please
take
a moment to review the archives at
http://archive.midrange.com/midrange-l.

--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
list To post a message email: MIDRANGE-L@xxxxxxxxxxxx To subscribe,
unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx Before posting, please take
a moment to review the archives at
http://archive.midrange.com/midrange-l.


--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
list To post a message email: MIDRANGE-L@xxxxxxxxxxxx To subscribe,
unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx Before posting, please take
a moment to review the archives at
http://archive.midrange.com/midrange-l.

--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx To subscribe,
unsubscribe,
or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx Before posting, please take a
moment to review the archives at http://archive.midrange.com/midrange-l
.


--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.


--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.

--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.







Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2014 by MIDRANGE dot COM and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available here. If you have questions about this, please contact