I used the Concurrent Maintenance and removed all four.
Stuck the four new ones about half way in.
Did Concurrent Maintance on the first two and got them shoved in and it
says ok. Read a bunch of email, did some sample sql to reply to someone's
email, etc. Configuration status still shows the four old S/N's and
models and non configured. Figured WTH and went on.
3. Work with disk units
3. Work with disk unit recovery
2. Disk unit problem recovery procedures
1. Initialize and format disk unit
Still shows those darn 4327's
Number Type Model Name Status
68-0C69B15 4327 050 DD016 Non-configured
68-0A7335D 4327 050 DD015 Non-configured
21-93EBE 4327 050 DD017 Non-configured
21-015FF28 4327 050 DD018 Non-configured
Picked this one
68-0A7335D 4327 050 DD015
Since it was in the first slot of the two disks that I put in.
Cannot determine if unit possibly configured
F10=Ignore problems and continue
Press F10 to confirm your choice for 1=Initialize and format.
Error or Problem
Disk unit I/O failure, check reference code
The system encountered an error while it was attempting to
read or write to a disk unit.
Contact your service representative with the following
Serial Resource I/O
Number Type Model Name Processor Device
68-0A7335D 4327 050 DD015 0000 3002