×
The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.
The bad disk was in the 3rd slot from the left (P2-D3).
The second disk was in the 8th slot on the extreme right. This disk did not
join the RAID set for some reason.
The disks were removed (when powered down) from DST after IPL'ing in Manual
mode. I never got the option to remove the disks from the configuration or
it would not work. As the machine is a model 520 it has only 1 RAID set.
I will point out that the first IPL after removing the disks worked. I could
see all the remaining disks. Parity was not enabled though. The system did
not show any missing or failed disks.
I then powered down again to restart the system and use DST in manual mode
to put the disk from slot 8 into slot 3.
How do you get 2 RAID sets with 1 RAID controller?
As the 8th drive was not showing in the RAID set, I could not remove it from
the RAID set.
Thanks.
Darryl Freinkel
Assignment 400 Group, Inc.
Tel: 770.321.8562 ext 111 | Fax 770.321.8562 | 2247 La Salle Dr, Marietta
GA, 30062, USA | PO Box 72556, Marietta, GA 30007-2556
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact
[javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
